In this case you directly connect to your RS485 EnOcean bus (use USB connection of an Eltako FAM14 e.g.). If everything is running fine you should see the base id of your gateway in the properties of your bridge.Īnother way to improve sending and reception reliability is to setup a wired connection. When using ser2net make sure to use telnet instead of raw in the set2net config file. In this case you have to define the path to the gateway like this rfc2217://x.x.x.x:3001.
#SMART TIMER OPENHAB SERIAL#
If you want to place the gateway for better reception apart from your openHAB server, you can forward its serial messages over TCP/IP ( ser2net). # Concepts/Configurationįirst of all you have to configure an EnOcean transceiver (gateway).Ī directly connected USB300 can be auto discovered, an EnOceanPi has to be added manually to openHAB.īoth gateways are represented by an EnOcean gateway in openHAB. This binding can enable the repeater function (level 1 or 2) of these gateways and retrieve detailed information about them. This binding has been developed on an USB300 gateway and was also tested with an EnOceanPi.Īs this binding implements a full EnOcean stack, we have full control over these gateways. The binding uses an EnOcean gateway to retrieve sensor data and control actuators.įor bidirectional actuators it is even possible to update the openHAB item state if the actuator gets modified outside of openHAB.
The EnOcean binding connects openHAB to the EnOcean ecosystem.
0 kommentar(er)
